EN ISO TOLERANCIAS · Norma ISO , Energia Sustentable · EN ISO TOLERANCIAS NORMA DE CALDERARIA ISO NORMA ISO Published on May | Categories: Documents | Downloads: | Comments: 0. views. NF EN ISO Welding – General tolerances for welded constructions. NF EN ISO Surface roughness characteristics of blast-cleaned steel substrates .
|Published (Last):||19 February 2008|
|PDF File Size:||7.66 Mb|
|ePub File Size:||1.86 Mb|
|Price:||Free* [*Free Regsitration Required]|
NORMA ISO 13920 EBOOK
The distances between the actual norma iso 13920 and the measur- ing plane shall be measured for example, see figure 7. Tolerance class Z has been dropped.
For dated references, subsequent amendments to or revisions of any of these publications apply to this European Standard only when incorporated in it by amendment or revision. Figures 1 to 5 show examples of norma iso the shorter angle leg, I, is to be represented.
NORMA ISO EBOOK
Calculated and norma iso 13920 tolerances, t, norma iso 1 Other norma iso of form and position e. A version norma iso any other language made by translation under the responsibility of a CEN member into its own language and notified to the Central Secretariat has the same norma iso 13920 as morma official versions.
The deviation shall be derived from the difference between the nominal size and the actual size. The actual size norma iso an angle shall be determined by applying suitable measuring devices tangentially to the weldment, but away from the norma iso 13920 immediately influenced by the weld.
A measuring plane shall be established parallel to the ref- erence plane and apart from the weldment, using the meas- uring devices ieo norma iso 13920 in 6. No notes for slide. General tolerances for linear izo angular dimensions and for shape and position as specified in this standard apply for weldments, welding assemblies norma iso 13920 welded structures etc.
Published on Apr 22, Instead of specifying norma nrma tol- erances, the tolerance classes according norma iso this standard may be used. Are you sure you want to Yes No. In this case, the reference point Tolerance over over concerned norma iso be indicated on the drawing.
It is to be multi- plied by the nodma, in m, of the shorter leg. Tolerances for angular dimensions The length of the shorter angle leg shall norma iso 13920 nroma to deter- mine, on the basis of table 2, which tolerances are 133920 apply. The distances between the actual surface and the measuring plane shall be measured example see figure 8.
The applicable tolerances are always norma iso 13920 which are stated in the drawing. This does not apply to temporary dimensions.
Download Norma ISO 13920
This norma iso 13920 not apply to temporary notma. The length of the leg may also be assumed to extend to a specified reference point.
Range of nominal sizes, I, in mm length or shorter leg 4.